will not obtain or supply firmware on your behalf. also makes no representations as to your right to install any such firmware on the product. also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. While many Allen-Bradley PLC products will have firmware already installed, makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Because is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. is not an authorized surplus dealer or affiliate for the Manufacturer of this product. Rockwell Disclaimer: The product is used surplus. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. Products sold by come with ’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. is not an authorized distributor, affiliate, or representative for the brands we carry. Where the SelectedRecipe is entered in the data entry field. Ideally they would enter the recipe name in a data entry field and select it that way.īut we also still want to be able to use the recipe viewer to select the recipe name. It is very cumbersome for the operator to scroll through all recipe names to select the one they want to use. I also have an application where I have close to 100 recipe names. Was there a solution posted to this question? I can't seem to find it. I am using Sysmac Studio v1.1.7, and an NA5 HMI. I looked at the VB functions, but the only one I could find that was close was the. This will lead to possibly writing the wrong recipe to the controller, as well as frustrate the user if they have to scroll through a hundred items to find the recipe again. Any time that a recipe is change or saved, the recipe viewer object always resets its view and selects the first recipe. I am looking for a way to programatically select a recipe. I figure out that all codes are need to be placed in vb code where is recipeViewer but still is not returning any value in NJ1_HMI_Loaded_Program variable. NJ1_HMI_Loaded_Program = RecipeViewer0.SelectedRecipe 'Selected reciped gets set here ReadRecipeFromController(RecipeViewer0.SelectedTemplate, RecipeViewer0.SelectedRecipe)ĭim rcpSelectedTemplate As String = GetSelectedRecipeTemplate("RECEPTY", "RecipeViewer0")ĭim rcpSelectedRcp As String = GetSelectedRecipe("RECEPTY", "RecipeViewer0") WriteRecipeToController(RecipeViewer0.SelectedTemplate, RecipeViewer0.SelectedRecipe) 'Code behind Page - Add local subroutines for the page. Are you sure that i should get the value without controller? I did a test i connect this button with your subroutine and this same. Im using a button which call subroutine DownloadRecipe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |